This driver is for the FT232RUSB to Serial Cable (CSI Part # 17394 - Black Cable). Support is for 32-bit and 64-bit Windows XP / Vista / 7/8/10.
 |
| FT232R USB UART |
Never use FTDI drivers on non-genuine FTDI devices, there have been brick-and-mortar issues in the past with devices having the device ID reset to 0000. While this has been fixed, please note that you were advised that FTDI has set the measure , warning in place to stop counterfeit devices.
Download FT232R USB UART Driver (FTDI chipset) Windows
USB to Serial RS232
Driver: FTDI CDM Drivers DOWNLOAD
OS: Windows 10, 8, 7 ,Vista, XP 64bit & 32bit
Version: 2.12.28
File Size: 1.32 MB
File Type: zip
USB to Serial RS232
Driver: FTDI CDM Drivers DOWNLOAD
OS: Windows 10, 8, 7 ,Vista, XP 64bit & 32bit
Version: 2.12.16
File Size: 2.02 MB
File Type: exe
USB to Serial RS232
Driver: FTDI CDM Drivers DOWNLOAD
OS: Windows 8, 7 ,Vista, XP 64bit & 32bit
Version: 2.08.28
File Size: 1.32 MB
File Type: zip
FT232R USB UART Driver Download
Mirror DOWNLOAD
The FT232R USB driver is a bit tricky to install. You must first uninstall the driver, disconnect from the Internet, and then install the driver again. The FT232R USB drivers below should be pulled to an area on your computer that you can find.
When installing the driver, the new port will be labeled "USB Serial Port" in Windows Device Manager.
Step 1:
Download the driver file and extract it to your hard controller where you can find it
Step 2:
- You must first uninstall the wrong drivers on your computer. In Windows, go to Control Panel and then Device Manager
- Now hit the Delete button on your computer and it will ask for confirmation.
- Collapse the Ports menu and now click on the USB controller at the bottom of the list.
- Now you need to uninstall the existing USB serial converter.
- Disconnect the USB cable from your PC to KMX1 or KMX2
- Reconnect the USB cable from your PC to KMX1 or KMX2
- A new item will appear with yellow flag FT232R USB UART
- Right click on FT232R USB UART
- Select Update Driver Software
- Now you need to find where you extracted the drivers from the file you downloaded earlier and point the software to the directory.
- The driver software for USB Serial Converter has been installed
- The USB serial converter is already installed. Next, you need to install the port. If you are old enough to remember software modems, you will remember that it was made the same way.
- The item marked in yellow will have been renamed to USB Serial Port
- Right click on the USB serial port
- Select Update Driver Software
- The driver software for the port is in the same directory where you had the other drivers you just installed.
- The serial port will now be installed and that will be the final installation. There should be no yellow flags anymore.
- Done!
0 Comment